DTC U3000-51
DTC U3000-51 : SRS Unit Programming Error
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed .
- This DTC is indicated when the SRS unit update is not completed properly.
- Do not press the engine start/stop button to select the ACC or OFF mode while updating the SRS unit. If you press the engine start/stop button to select the ACC or OFF mode before you complete the SRS unit update procedure, the SRS unit can be damaged.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
| DTC Description | DTC |
|---|---|
| U3000-51 SRS unit programming error |
DTC (SRS)
- System check
-1. Do the SRS unit update procedure .
-2. Clear the DTCs with the HDS .
-3. Press the engine start/stop button to select the ON mode, then wait for 10 seconds.
-4. Check for DTCs with the HDS .
DTC Description DTC U3000-51 SRS unit programming error Is DTC U3000-51 indicated?
YES
NO
Update is complete.