DTC U3000-51 (SRS Unit)
WARNING: This page is about a different car, the 2022 Honda Accord, 2021 Honda Accord, 2020 Honda Accord, 2019 Honda Accord, and 2018 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
DTC U3000-51 : SRS Unit Programming Error
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components of the correct part number and were properly installed .
- This DTC is indicated when the SRS unit update is not completed properly.
- Never press the engine start/stop switch, while updating the SRS unit. If you press the engine start/stop switch, before you complete the SRS unit update procedure, the SRS unit can be damaged. If there is a problem with the update, keep the vehicle in ON mode.
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures and General Troubleshooting Information .
| DTC Description | DTC |
|---|---|
| U3000-51 SRS unit programming error |
DTC (SRS)
- Problem verification (update)
-1. Apply the parking brake.
-2. Do the SRS unit update procedure .
-3. Clear the DTCs with the HDS.
-4. Turn the vehicle to the ON mode, then wait for 10 seconds.
-5. Check for DTCs with the HDS.
DTC Description DTC U3000-51 SRS unit programming error Is DTC U3000-51 indicated?
YES
The failure is duplicated. Check for any authorized service information related to the DTCs or symptoms you are troubleshooting or replace the SRS unit .
NO
Update is complete.