Transmission Range Switch Removal and Installation(A/T) (2013 2014 2015): Installation

Transmission Range Switch - Install

Courtesy of HONDA, U.S.A., INC.

1. Make sure the selector control shaft is in the N position. If necessary, move the selector control shaft to the N position.

NOTE: Do not use the selector control shaft to adjust the shift position. If the selector control shaft tips are squeezed together it will cause a faulty signal or position due to play between the selector control shaft and the transmission range switch.

Courtesy of HONDA, U.S.A., INC.

2. Align the cutouts (A) on the rotary-frame with the neutral positioning cutouts (B) on the transmission range switch (C), then put a 2.0 mm (0.079 in) feeler gauge blade (D) in the cutouts to hold the transmission range switch in the N position.

NOTE: Be sure to use a 2.0 mm (0.079 in) blade or equivalent to hold the transmission range switch in the N position.

Courtesy of HONDA, U.S.A., INC.

3. Install the transmission range switch (A) gently on the selector control shaft (B) while holding it in the N position with the 2.0 mm (0.079 in) blade (C).

Fig 1: Transmission Range Switch With Torque Specifications

Courtesy of HONDA, U.S.A., INC.

4. Tighten the bolts on the transmission range switch (A) while you continue holding the N position.

NOTE: Do not move the transmission range switch when tightening the bolts.

5. Remove the feeler gauge (B).

Transmission Range Switch Connector - Connect

Courtesy of HONDA, U.S.A., INC.

1. Check the connector (A) for corrosion, dirt, or oil, and clean or repair if necessary, then connect the transmission range switch connector securely.

Transmission Range Switch Cover - Install

Fig 2: Transmission Range Switch Cover With Torque Specifications
Courtesy of HONDA, U.S.A., INC.

1. Install the transmission range switch cover (A).
Front Splash Shield - Install

1. Install the front splash shield .