LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front And Rear Suspension (Inspection) (4-CYL) >> Wheel Bolt Replacement >> Front

Wheel Bolt Replacement: Front

  1. Remove the front hub (see KNUCKLE/HUB REPLACEMENT ).
  2. Separate the wheel bolt (A) from the hub (B) using a hydraulic press. Support the hub with hydraulic press attachments (C) or equivalent tools.
    NOTE: Before installing the new wheel bolt, clean the mating surfaces on the bolt and the hub.
    Fig 1: Identifying Wheel Bolt (A), Hub (B) And Hydraulic Press Attachments (C)
    G07769158Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Insert the new wheel bolt into the hub while aligning the splined surfaces on the hub hole with the wheel bolt.
    NOTE:
    • Degrease the area around the wheel bolt.
    • Make sure the wheel bolt is installed vertically to the hub disc surface.
  4. Install the wheel bolt using a hydraulic press until the wheel bolt shoulder is fully seated.
  5. Install the front hub (see KNUCKLE/HUB REPLACEMENT ).
NOTE: If you cannot tighten the wheel nut to the specified torque when installing the wheel, replace the front hub as an assembly.
scientia non olet · About LEMON Manuals