LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> Suspension >> Front Suspension >> Front And Rear Suspension (Inspection) (4-CYL) >> Ball Joint Boot Inspection/Replacement >> Front knuckle/Front upper arm/Rear upper arm

Front knuckle/Front upper arm/Rear upper arm

  1. Check the ball joint boot for weakness, damage, cracks, and grease leaks.
    NOTE:
    • If the ball joint boot is damaged and leaks grease, replace the appropriate part as an assembly.
    • If the ball joint boot is weak and cracked but does not leak grease, go to step 2. Replace the appropriate ball joint boot.
  2. Disconnect the appropriate ball joint connection, and remove the component including the ball joint:
  3. Paint a alignment mark (A) in the center between the both boot clip end faces (B) on the appropriate part (C).
    Fig 1: Identifying Alignment Mark (A), Boot Clip End Faces (B) And Appropriate Part (C)
    G07769164Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the boot clip and the boot.
  5. Pack the interior and lip (A) of a new boot with grease. Keep the grease off of the boot-to-housing mating surfaces (B).
    NOTE: Use the grease that comes with the ball joint kit, or multi-purpose grease.
    Fig 2: Identifying Lip (A), Housing Mating Surfaces (B) And Base (C)
    G07769165Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Pack fresh grease into the base (C). Do not let dirt or other foreign materials get into the boot.
  7. Install the boot on the ball joint, then squeeze it gently to force out any air, then wipe the grease off the tapered portion of the ball joint pin (D).
  8. The front knuckle ball joint or the rear upper arm ball joint: Adjust the depth by turning the clip guide until its base is just above the groove around (A) the bottom of the boot. Then slide the clip (B) over the tool and into position on the boot.
    Fig 3: Identifying Groove Around (A) And Boot Clip (B)
    G07769166Courtesy of AMERICAN HONDA MOTOR CO., INC.
  9. The front upper arm ball joint: Adjust the ball joint boot clip guide with the adjusting bolt (A) until its base is just above the groove around (B) the bottom of the boot. Then slide the clip (C) over the clip guide and into position on the boot.
    Fig 4: Identifying Adjusting Bolt (A), Groove Around (B) And Boot Clip (C)
    G07769167Courtesy of AMERICAN HONDA MOTOR CO., INC.
  10. Align the center between the both end faces of the boot clip to alignment mark of the appropriate part.
  11. After installing a boot, wipe any grease off the exposed portion of the ball joint pin.
  12. Install all of the removed parts.
scientia non olet · About LEMON Manuals