LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) (4-CYL) >> Driver's Airbag Replacement >> Removal

Driver's Airbag Replacement: Removal

  1. Do the battery terminal disconnection procedure (see BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Remove the access panel (A) from the steering wheel, then disconnect the cable reel 4P connector (B) from the driver's airbag 4P connector.
    Fig 1: Identifying Access Panel (A) And Cable Reel 4P Connector (B)
    G07772123Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the two TORX bolts (A) using a TORX T30 bit.
    Fig 2: Identifying Torx Bolts (A)
    G07772124Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the driver's airbag (B).
scientia non olet · About LEMON Manuals