A/C Refrigerant Oil Replacement

Special Tools Required 

Oil Injector Tool Robinair ROB16256*, commercially available

*: Available through the Acura Tool and Equipment Program; call 888-424-6857

Recommended PAG oil: SP-10

P/N 38897-P13-A01AH: 120 mL (4 fl-oz)

Add the recommended refrigerant oil in the amount listed if you replace any of the following parts.

• To avoid contamination, do not return the oil to the container once dispensed, and never mix it with other refrigerant oils.
• Immediately after using the oil, reinstall the cap on the container, and seal it to avoid moisture absorption.
• Do not spill the refrigerant oil on the vehicle; it may damage the paint; if it gets on the paint, wash it off immediately.

A/C condenser (including dryer desiccant)................50 mL (1 2/3 fl-oz)

Evaporator..............40 mL (1 1/3 fl-oz)

Line or hose............10 mL (1/3 fl-oz)

Leakage repair........25 mL (5/6 fl-oz)

Dryer desiccant........10 mL (1/3 fl-oz)

A/C compressor......Since the oil separator is equipped inside the A/C compressor for this vehicle, oil drainage is unnecessary at the time of A/C compressor replacement.