Transmission Fluid Inspection and Replacement

WARNING: This page is about a different variant/trim than selected.

Raise the vehicle on a lift, and make sure it is securely supported.
Remove the engine undercover (A) from the front splash shield.

Fig 1: Identifying Engine Undercover (A)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the filler plug (A) and the sealing washer (B). Check the condition of the MTF and make sure it is at the proper level (C).

Fig 2: Identifying Filler Plug (A) And Sealing Washer (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the fluid is dirty, remove the drain plug (A) and the sealing washer (B), and drain the MTF.

Fig 3: Drain Plug (A) And Sealing Washer (B) With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the drain plug with a new sealing washer, and refill the transmission with MTF to the proper level. Always use Acura Manual Transmission Fluid (MTF).
Fluid Capacity:

1.9 L (2.0 US qt) at fluid change

2.0 L (2.1 US qt) at overhaul
Install the filler plug (C) with a new sealing washer (D).
Install the engine undercover (A) to the front splash shield.

Fig 4: Engine Undercover (A) With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Lower the vehicle.
Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 on GENERAL TROUBLESHOOTING INFORMATION ).
Turn the ignition switch to ON (II).
Make sure the HDS communicates with the vehicle and the engine control module (ECM). If it does not communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
Select GAUGES in the BODY ELECTRICAL with the HDS.
Select ADJUSTMENT in the GAUGES with the HDS.
Select MAINTENANCE MINDER in the ADJUSTMENT with the HDS.
Select RESET in the MAINTENANCE MINDER with the HDS.
Select RESETTING THE MTF LIFE with the HDS.