Mainshaft Disassembly

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to the Exploded View in the Mainshaft Reassembly, as needed, when removing components pressed onto the mainshaft (see MAINSHAFT REASSEMBLY ).

Remove the angular ball bearing (A) using a commercially available bearing separator (B) and a commercially available bearing puller (C).

Fig 1: Removing Angular Ball Bearing (A) Using A Commercially Available Bearing Separator (B) And A Commercially Available Bearing Puller (C)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 5th gear (A) on steel blocks, and press the mainshaft out of the 5th/6th synchro hub (B) and 5th gear.
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.

Fig 2: Supporting 5Th Gear (A) On Steel Blocks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 3rd gear (A) on steel blocks, and press the mainshaft out of the 3rd/4th synchro hub (B) and 3rd gear.
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.

Fig 3: Supporting 3Rd Gear (A) On Steel Blocks

Courtesy of AMERICAN HONDA MOTOR CO., INC.