Countershaft Disassembly

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to the Exploded View in the Countershaft Reassembly, as needed, when removing components pressed onto the countershaft (see COUNTERSHAFT REASSEMBLY ).

Securely clamp the countershaft assembly in a bench vise with wood blocks.

Fig 1: Clamping Countershaft Assembly In A Bench Vise With Wood Blocks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the special bolt (left-hand threads).
Support 6th gear (A) on steel blocks (B), then use a press (C) and an attachment (D) to press the countershaft out of the ball bearing and 6th gear.

Fig 2: Supporting 6Th Gear (A) On Steel Blocks (B), Using A Press (C) And An Attachment (D)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the 35 mm shim.
Support 4th gear (A) on steel blocks (B), then use a press (C) and an attachment (D) to press the countershaft (E) out of 4th gear and 5th gear.

Fig 3: Supporting 4Th Gear (A) On Steel Blocks (B), Using A Press (C) And An Attachment (D) To Press Countershaft (E)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 2nd gear (A) on steel blocks (B), then use a press (C) and an attachment (D) to press the countershaft (E) out of 2nd gear and 3rd gear.

Fig 4: Support 2nd Gear (A) On Steel Blocks (B), Using Press (C) And An Attachment (D) To Press Countershaft (E)

Courtesy of AMERICAN HONDA MOTOR CO., INC.