Countershaft Bearing Replacement

Special Tools Required 

• Oil Seal Driver, 65 mm 07JAD-PL90100
• Adjustable Bearing Puller, 25-40 mm 07736-A01000B
• Slide Hammer 3/8"-16 UNF, commercially available

1. Remove the bearing set plate (A) from the clutch housing (B).
   Fig 1: Identifying Bearing Set Plate (A) From Clutch Housing (B)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the needle bearing (A) using the 25-40 mm adjustable bearing puller (B) and a commercially available 3/8"-16 UNF slide hammer (D), then remove oil guide plate C.
   Fig 2: Removing Needle Bearing (A) Using Adjustable Bearing Puller (B) And A Commercially Available Slide Hammer (D)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Position oil guide plate C and a new needle bearing (A) in the bore of the clutch housing (B).
   Fig 3: Positioning Oil Guide Plate C And A New Needle Bearing (A) In Bore Of Clutch Housing (B)

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the needle bearing using the 65 mm oil seal driver (D).
5. Install the bearing set plate (A) with the flange bolts (B).

Fig 4: Bearing Set Plate (A) With Flange Bolts (B) With Torque Specifications

Courtesy of AMERICAN HONDA MOTOR CO., INC.