Backlash Inspection

WARNING: This page is about a different variant/trim than selected.

Install the driveshaft and the intermediate shaft into the differential assembly.
Carefully clamp the driveshaft (A) in a bench vise (B).

Fig 1: Identifying Driveshaft (A) And Bench Vise (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Place the intermediate shaft (C) on a V-block (D), then fix the intermediate shaft using vise grips or equivalent (E).
Measure the backlash of the final driven gear (F) with a dial indicator (G). If the backlash is not within the standard, check the differential carrier and replace it if necessary.
Standard (New): 0.8-1.3 mm (0.031-0.051 in)