Passenger's Dashboard Undercover Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the passenger's dashboard undercover (A).
- 1. Gently pull down the rear edge to detach the clips.
- 2. Pull the undercover away to release the pins (B) from the holders (C).
- 3. Disconnect the footwell light connector (D) and the HandsFreeLink control unit connector (E).
Fig 1: Identifying Passenger'S Dashboard Undercover, Pins, Holders Footwell, Light Connector And Handsfreelink Control Unit Connector
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Make sure the pins of the undercover are installed securely to the holders.
- Push the clips into place securely.