Driver's Dashboard Undercover Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the dashboard or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ).
Remove the driver's dashboard undercover (A).
- 1. Gently pull down the rear edge to detach the clips.
- 2. Pull the undercover rearward to release its holder (B) from the pin (C).
- 3. Disconnect the footwell light connector (D).
Fig 1: Identifying Driver'S Dashboard Undercover, Holder, Pin And Footwell Light Connector With Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the footwell light connector is plugged in properly.
- Make sure the holder of the undercover is installed securely to the pin.
- Push the clips into place securely.