Glass Position Adjustment

The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/-1 mm (0+0.04/-0.04 in) all the way around, and the weatherstrip should evenly touch the roof panel at the front and rear. If not, make the following adjustment:

Fig 1: Identifying Clearance Between Roof Panel And Glass Weatherstrip

Courtesy of AMERICAN HONDA MOTOR CO., INC.

1. Remove the bracket cover (see step  3 on ).
2. Adjust the glass (A).
   1. Slightly loosen the TORX bolts with a TORX T25 bit.
   2. Move the glass up or down and forward or rearward.
   3. Tighten all bolts securely.
      Fig 2: Glass Torx Bolts With Torque Specifications

      Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. If necessary, repeat on the opposite side.
4. Reset the moonroof control unit (see RESETTING THE MOONROOF CONTROL UNIT ).
5. Check for water leaks (see step 9 on DOOR GLASS ADJUSTMENT ). Use free-flowing water from a hose without a nozzle. Do not use high-pressure spray.
   NOTE: It is normal for some water, to seep past the moonroof into the moonroof frame, and exit through the drains.