Seat Cushion

NOTE: Take care not to scratch the body or tear the seat covers.

Fold down both seat-backs.
Pull back the front area of the trunk floor (see step 2 on TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
Remove the bolt securing the seat cushion (A) from behind the left seat-back (B).

Fig 1: Seat Cushion, Left Seat-Back And Bolt With Torque Specification
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Raise both seat-backs.
While pushing down on the seat cushion (A), pull the seat hook handles (B) to release the hooks (C).

Fig 2: Pulling Seat Hook Handles
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull back the seat cushion to pull out the seat belt buckles (D) from the holes in the seat cushion. Release the center seat belt (E) and the center seat belt buckle (F) from their slits (G), and remove seat cushion.
Install the seat cushion (A) in the reverse order of removal. When installing the seat cushion, first install the seat belt buckles (B) into the holes (C). Slip the center seat belt buckle (D) and the center seat belt (E) through the slits (F) in the seat cushion.

NOTE: Make sure there are no twists or kinks in the seat belts before the seat cushion is installed.

Fig 3: Identifying Seat Cushion, Seat Belt Buckles, Holes, Center Seat Belt Buckle, Center Seat Belt And Slits

Courtesy of AMERICAN HONDA MOTOR CO., INC.