LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> FENDERWELL (4-CYL) >> Front Inner Fender Replacement

Front Inner Fender Replacement

NOTE:
  • Put on gloves to protect your hands.
  • Take care not to scratch the body.
  • When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
  1. Remove the front wheel (see KNUCKLE/HUB REPLACEMENT ).
  2. Remove the front inner fender (A).
    • 1. Canada models: On the back of the wheel arch, remove the screws (B), and remove the front splash guard (C).
    • 2. From under the front bumper (D), detach the clip (E) securing the front bumper, the splash shield (F), and the front inner fender, and detach the clips (G) securing the front bumper and the front inner fender.
    • 3. From the wheel arch, remove the screw (H) securing the front bumper and the front inner fender.
    • 4. From the wheel arch, detach the clips (I, J, K) securing the front inner fender (and splash shield) to the body.
    NOTE: To release the clips E, G, I, pry up on the center pin at the notch (L).
    Fig 1: Identifying Front Inner Fender Screw And Clip Location
    G07770215Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the inner fender in the reverse order of removal, and note these items:
    • If the clips are damaged or stress-whitened, replace them with new ones.
    • Push the clips into place securely.
scientia non olet · About LEMON Manuals