Rear Bumper Removal/Installation-Sedan

NOTE:

Have an assistant help you when removing and installing the rear bumper.
Put on gloves to protect your hands.
Take care not to scratch the rear bumper or the body.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Remove the caps (A). Remove the clips (B), screws (C, D), and bolts (E) securing the rear bumper (F).
NOTE: To release the clips, pry up on the center pin at the notch (G).

Fig 1: Rear Bumper Caps, Clips, Screws, Bolts And Notch With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull out the rear bumper (A) at both wheel arch areas to release it from the hooks (B) on both side spacers (C).

Fig 2: Pulling Out Rear Bumper At Both Wheel Arch Areas
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With the help of an assistant, pull out both sides of the rear bumper (A) to release the hooks (B) on both rear spacers (C).

Fig 3: Pulling Out Both Sides Of Rear Bumper
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With the help of an assistant, pull out the rear bumper (A) to release the hooks (B) on both upper brackets (C).

Fig 4: Identifying Rear Bumper, Hooks And Upper Brackets
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If necessary, release the hooks (A) and the posts (B), then remove the rear bumper absorber (C) from the rear bumper beam (D).

Fig 5: Identifying Rear Bumper Beam, Rear Bumper Absorber, Hooks And Posts
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the bumper in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the rear bumper engages the hooks (of both side spacers and both rear spacers) on each side securely.
- Push the clips, the hooks, and the posts into place securely.