Front Bumper Removal/Installation - Sedan

NOTE:

Have an assistant help you when removing and installing the front bumper.
Put on gloves to protect your hands.
Take care not to scratch the front bumper or the body.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Remove the front grille cover (see FRONT GRILLE COVER REPLACEMENT ).
Remove the screws (A) and clips (B, C, D) securing the front bumper (E).
NOTE: To release the clips, pry up on the center pin at the notch (F).

Fig 1: Identifying Front Bumper Screws And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull out the front bumper (A) at both wheel arch areas to release it from the hooks (B) on both side spacers (C).

Fig 2: Pulling Out Front Bumper
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With the help of an assistant, pull both sides of the front bumper (A) away from both side spacers, then pull out the bumper to release the hooks (B) from both upper beams (C).

Fig 3: Pulling Both Sides Of Front Bumper
Courtesy of AMERICAN HONDA MOTOR CO., INC.
With the help of an assistant, disconnect the fog light connectors (A) while holding the front bumper (B), then remove the bumper.

Fig 4: Identifying Fog Light Connectors And Front Bumper
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If necessary, release the hooks (A) and the posts (B), then remove the front bumper absorber (C) from the front bumper beam (D).

Fig 5: Identifying Hooks, Posts, Front Bumper Absorber And Front Bumper Beam
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the bumper in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Make sure the front bumper engages the hooks (of both upper beams and both side spacers) on each side securely.
- Push the clips, the hooks, and the posts into place securely.