Vanity Mirror Light Test/Replacement

Remove the sunvisor (see SUNVISOR REMOVAL/INSTALLATION ).
Disconnect the 2P connector (A) from the sunvisor (B).
Vanity Mirror Light: 2 W x 2

Fig 1: Identifying 2P Connector (A) And Sunvisor (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between terminals No. 1 and No. 2.
- With the vanity mirror cover (C) opened, there should be continuity.
- With the vanity mirror cover closed, there should be no continuity.
If the continuity is not as specified, check the bulbs (D). If the bulbs are OK, replace the sunvisor (see SUNVISOR REMOVAL/INSTALLATION ).
Install the parts in the reverse order of removal.