Front Individual Map Light Test/Replacement

Turn the map light switch OFF.
Carefully pry the lens (A) off with a small screwdriver.
Front Individual Map Light: 8 W x 2

Fig 1: Identifying Lens (A) And Individual Map Lights (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the screws, then remove the front individual map lights (B).
Disconnect the connectors (C) from the lights.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Identifying Connectors (C)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, check the bulb(s). If the bulb(s) are OK, replace the map lights.
Install the lights in the reverse order of removal.