Retainer Replacement
- Gradually scrape off the adhesive tape (A) under the retainers (B) while heating it with a heat gun to about 212-248°F (100-120°C).
NOTE:
- Do not overheat the painted surface around the retainers.
- To keep the exterior resin parts near the A-pillar from being overheated by the heat gun, wrap them with aluminum foil.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Clean the body bonding surface with a shop towel dampened with isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
- Install the upper retainers (A) and the lower retainer (B).
- 1. Peel the adhesive backing away from the retainers.
- 2. Line up the retainers with the alignment marks (C) on the body, and attach the retainers with the adhesive tape (D).
- 3. Apply the two-part epoxy adhesive (E) around the edge of the retainers as shown.
Courtesy of AMERICAN HONDA MOTOR CO., INC.