Roof Molding Replacement - Sport Wagon

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the body.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the roof rail and the center bracket (see ROOF RAIL REPLACEMENT ).
Starting at the rear edge of each roof molding, pull up the front roof molding (A), the center roof molding (B), and the quarter roof molding (C). Slide the moldings rearward, and pull up the moldings to release the brackets (D) from the pins (E), then remove the moldings from body.

Fig 1: Pulling Up Front Roof Molding, Center Roof Molding And Quarter Roof Molding
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the molding in the reverse order of removal, and note these items:
- Front roof molding: Take care not to damage the windshield molding.
- Make sure the roof molding is installed securely.
Fig 2: Installing Molding
Courtesy of AMERICAN HONDA MOTOR CO., INC.