Roof Molding Replacement - Sedan

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the body.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Apply the protective tape (A) to the body. Pry up on the roof molding (B) with a trim tool.

Fig 1: Prying Up Roof Molding Using Trim Tool
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull up and slide the roof molding to release the front bracket (C) from the pin (D).
Pull up the front area of the roof molding (A).

Fig 2: Pulling Up Front Area Of Roof Molding
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Pull up and release the rear bracket (A) from the pin (B), then remove the roof molding (C).

Fig 3: Removing Roof Molding
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the molding in the reverse order of removal, and note these items:
- Take care not to damage the windshield molding.
- Make sure the roof molding is installed securely.

Fig 4: Installing Molding

Courtesy of AMERICAN HONDA MOTOR CO., INC.