Hazard Warning Switch Test/Replacement

Remove the audio-navigation switch panel^*1 (see AUDIO-NAVIGATION SWITCH PANEL REMOVAL/INSTALLATION ) or audio unit^*2 (see AUDIO UNIT REMOVAL/INSTALLATION ).
*1: With navigation

*2: Without navigation
Disconnect the 5P connector (A) from the hazard warning switch (B).

Fig 1: Identifying 5P Connector (A) And Hazard Warning Switch (B)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the two screws and the hazard warning switch.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Checking Continuity Between Terminals In Each Switch Position
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the hazard warning switch.
Install the switch in the reverse order of removal.