Trunk Lid Latch Replacement

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the trunk lid.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Take care not to kink the cable.

Remove the trunk lid trim panel (see TRIM REMOVAL/INSTALLATION - TRUNK LID ).
Insert a trim tool through the latch cover (A) opening, and pry on the cover to release the hooks (B). Pull out the cover, and release the tab (C) from the trunk lid latch (D), then remove the latch cover.

Fig 1: Latch Cover, Hooks, Cover, Tab And Trunk Lid Latch With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the trunk lid latch connector (E), and remove the bolts, then remove the latch.
Disconnect the trunk lid opener cable (A).

Fig 2: Disconnecting Trunk Lid Opener Cable
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the latch in the reverse order of removal, and note these items:
- Make sure the connector is plugged in properly, and the opener cable is connected properly.
- Make sure the trunk lid opens properly and locks securely.
- Fix the original position of the outer end of cable (A) on the trunk lid latch securely. And check the trunk lid latch operation: Make sure the trunk lid latch unlock when turning the trunk lid cylinder with a key. If necessary, adjust the position of the cable end.
  
  Fig 3: Identifying Trunk Lid Latch Cable
  Courtesy of AMERICAN HONDA MOTOR CO., INC.