LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TL SH-AWD, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (M/T Clutch) >> Slave Cylinder Replacement >> O-ring Replacement

O-ring Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the slave cylinder.
  2. Remove the roll pins (A), then remove the clutch line connector (B) and the O-ring (C) from the slave cylinder (D).
    Fig 1: Identifying Roll Pins, Clutch Line Connector, O-Ring And Slave Cylinder
    G08069973Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Install the clutch line connector (A) with a new O-ring (B), then set in new roll pins (C) to the slave cylinder (D).
    Fig 2: Identifying Clutch Line Connector, O-ring, Roll Pins And Slave Cylinder
    G08069974Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Install the slave cylinder.
scientia non olet · About LEMON Manuals