Transmission Housing Bearing Replacement

Special Tools Required 

• Bearing Driver Attachment, 72 x 75 mm 07746-0010600
• Driver Handle, 15 x 135L 07749-0010000

1. Remove the transfer output shaft bearing (A) from the transmission housing (B) by heating the transmission housing to about 212 °F (100 °C) using a heat gun (C). Do not heat the transmission housing more than 212°F(100°C).
   Fig 1: Removing Transfer Output Shaft Bearing From Transmission Housing By Heating Transmission Housing Using Heat Gun

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing (A) in the transmission housing.
   Fig 2: Identifying Bearing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Drive a new bearing until it bottoms in the transmission housing using the driver handle (A) and the 72 x 75 mm bearing driver attachment (B).
   Fig 3: Driving Bearing In Transmission Housing Using Driver Handle And Bearing Driver Attachment

   Courtesy of AMERICAN HONDA MOTOR CO., INC.