Transfer Hypoid Drive Gear Bearing Replacement

Special Tools Required 

• Bearing Driver Attachment, 42x47 mm 07746-0010300
• Driver Handle, 15 x 135L 07749-0010000
• Installer Attachment 40 mm 07LAD-PW50601

1. Remove the tapered roller bearing (A) from the transfer hypoid drive gear (B) using the 15 x 135L driver handle (C), the 42 x 47 mm bearing driver attachment (D), a bearing separator (E), and a press.
   Fig 1: Removing Tapered Roller Bearing From Transfer Hypoid Drive Gear Using Driver Handle, Bearing Driver Attachment, Bearing Separator And Press

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing on the transfer hypoid drive gear using the 15 x 135L driver handle (A), the 40 mm installer attachment (B), 42 x 47 mm bearing driver attachment (C), and a press.
   Fig 2: Installing Bearing On Transfer Hypoid Drive Gear Using Driver Handle, Installer Attachment, Bearing Driver Attachment And Press

   Courtesy of AMERICAN HONDA MOTOR CO., INC.