Transfer Breather Hose Replacement

WARNING: This page is about a different variant/trim than selected.

Raise the vehicle on a lift, and make sure it is supported securely.
Remove the transfer breather box (A) from its bracket (B).

Fig 1: Identifying Breather Box, Bracket, Breather Hose And Hose Clamp
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the breather hose (C) from the hose clamp (D).
Remove the breather hose (A) from the hose clamp (B).

Fig 2: Identifying Breather Hose And Hose Clamp
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the breather hose (A) from the transfer breather pipe (B), and remove the breather hose from the hose clamp (C).

Fig 3: Identifying Breather Hose, Breather Pipe, Hose Clamp And Dot Marks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Connect the breather hose over the breather pipe with facing the dot mark (D) to the rear side of the vehicle, and install the hose on the hose clamp at the dot mark (E).
Install the breather hose (A) on the hose clamp (B).

Fig 4: Identifying Breather Hose And Hose Clamp
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the transfer breather box (A) on its bracket (B).

Fig 5: Identifying Breather Box, Bracket, Breather Hose And Hose Clamp
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the breather hose (C) on the hose clamp (D).