Shift Arm Clearance Inspection

WARNING: This page is about a different variant/trim than selected.

Measure the clearance between the shift arm (A) and the shift piece (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2.
Standard: 0.26- 0.57 mm (0.010- 0.022 in)

Service Limit: 0.75 mm (0.029 in)

Fig 1: Measuring Clearance Between Shift Arm And Shift Piece Using Feeler Gauge
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Measure the width of the shift arm.
- If the width is not within the standard, replace the shift arm.
- If the width is within the standard, replace the shift piece.
Standard: 13.6- 13.8 mm (0.535- 0.543 in)

Fig 2: Measuring Shift Arm Width
Courtesy of AMERICAN HONDA MOTOR CO., INC.