Mainshaft Oil Seal Replacement

Special Tools Required 

• Bearing Driver Attachment, 42 x 47 mm 07746-0010300
• Driver Handle, 15 x 135L 07749-0010000

1. Remove the oil seal (A) from the clutch housing.
   NOTE: Be careful not to damage the clutch housing while removing the oil seal.
   Fig 1: Removing Oil Seal From Clutch Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Drive in a new oil seal flush with the clutch housing using the 15 x 135L driver handle (A) and the 42 x 47 mm bearing driver attachment (B).
   Fig 2: Driving In Oil Seal Flush With Clutch Housing Using Driver Handle And Bearing Driver Attachment

   Courtesy of AMERICAN HONDA MOTOR CO., INC.