Mainshaft Disassembly

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to the EXPLODED VIEW in the Mainshaft Reassembly, as needed, when removing components pressed onto the mainshaft (see MAINSHAFT REASSEMBLY ).

Support 6th gear (A) on steel blocks, and press the mainshaft out of the angular ball bearing (B) and 6th gear using an attachment (C) and a press (D).
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.

Fig 1: Supporting 6th Gear On Steel Blocks And Pressing Mainshaft Out Of Angular Ball Bearing And 6th Gear Using Attachment And Press
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 5th gear (A) on steel blocks, and press the mainshaft out of the 5th/6th synchro hub (B) and 5th gear using an attachment (C) and a press (D).
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.

Fig 2: Supporting 5th Gear On Steel Blocks And Press Mainshaft Out Of 5th/6th Synchro Hub And 5th Gear Using Attachment And Press
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 3rd gear (A) on steel blocks, and press the mainshaft out of the 3rd/4th synchro hub (B) and 3rd gear using an attachment (C) and a press (D).
NOTE: Do not use a jaw-type puller; it can damage the gear teeth.

Fig 3: Supporting 3rd Gear On Steel Blocks And Pressing Mainshaft Out Of 3rd/4th Synchro Hub And 3rd Gear Using Attachment And Press
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support the angular ball bearing (A) on steel blocks, and press out the mainshaft using an attachment (B) and a press (C).

Fig 4: Supporting Angular Ball Bearing On Steel Block And Pressing Out Mainshaft Using Attachment And Press
Courtesy of AMERICAN HONDA MOTOR CO., INC.