Countershaft Bearing Replacement

Special Tools Required 

• Bearing Driver Attachment, 72 x 75 mm 07746-0010600
• Driver Handle, 15 x 135L 07749-0010000
• Adjustable Bearing Puller, 45-75 mm 07YAC-0010100
• Slide Hammer 3/8"-16 UNF, commercially available

1. Remove the bearing set plate (A) from the clutch housing (B).
   Fig 1: Identifying Bearing Set Plate And Clutch Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the needle bearing (A) from the clutch housing (B) using the 45- 75 mm adjustable bearing puller (C) and a commercially available 3/8"-16 UNF slide hammer (D).
   Fig 2: Removing Needle Bearing From Clutch Housing Using Adjustable Bearing Puller And UNF Slide Hammer

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install a new needle bearing (A) using the 15 x 135L driver handle (B) and the 72 x 75 mm bearing driver attachment (C).
   Fig 3: Installing Needle Bearing Using Driver Handle And Bearing Driver Attachment

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the bearing set plate (A).
   Fig 4: Bearing Set Plate With Torque Specifications

   Courtesy of AMERICAN HONDA MOTOR CO., INC.