DTC P07E4, P07E6 (2016 2017 2018 2019 2020)
DTC P07E4 : Unable to Engage Park DTC P07E6 : Stuck in Park
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information .
- The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
- This code can be caused if the parking lock is released by using the tool or parking release lever and the vehicle is turned to the ON mode.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P07E4 Unable to Engage Park | |||
| P07E6 Stuck in Park |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine.
- 4. While pressing the brake pedal, shift the transmission to R position/mode, N position/mode, D position/mode, and then shift to P position/mode for at least 1 second.
- 5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P07E4 Unable to Engage Park P07E6 Stuck in Park Is DTC P07E4 or P07E6 indicated?
YES
The failure is duplicated. Replace the sensor unit (2016 2017 2018 2019 2020) .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.