DTC P0780 (2016 2017 2018 2019 2020)
DTC P0780 : Shift Error
- Before you troubleshoot, review the General Troubleshooting Information .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
- The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
- Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0780 Shift Error |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Test-drive the vehicle at a speed of 19 mph (30 km/h) or more in D position/mode for several minutes under the same conditions as those indicated by the freeze data.
- 4. Test-drive the vehicle in R position/mode for several minutes under the same conditions as those indicated by the freeze data.
- 5. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0780 Shift Error Is DTC P0780 indicated?
YES
The failure is duplicated. Replace the sensor unit (2016 2017 2018 2019 2020) or Replace the transmission - Refer to: Automatic Transmission Removal and Installation (2014 2015), or Automatic Transmission Removal and Installation (2016 2017 2018 2019 2020) .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals at the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.