DTC P0764 (2016 2017 2018 2019 2020)
DTC P0764 : Shift Solenoid Valve C Intermittent
Before you troubleshoot, review the General Troubleshooting Information .
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0764 Shift Solenoid Valve C Intermittent |
DTC (A/T)
- DTC check
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Test-drive the vehicle under the auto idle stop system operating condition, and stop the engine by the system.
- 4. Wait for at least 5 minutes, then turn the vehicle to the OFF (LOCK) mode.
- 5. Turn the vehicle to the ON mode.
- 6. Check for other Pending or Confirmed DTCs indicated along with DTC P0764.
DTC Description Confirmed DTC Pending DTC Freeze Frame Are there other DTCs?
YES
Go to the indicated DTC's troubleshooting .
NO
There are no DTCs along with DTC P0764. Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals between the sensor unit and the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.