LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> MDX SH-AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - DTC Diagnostics (1 Of 2) (Except Hybrid) >> Troubleshooting >> DTC P0741 (2016 2017 2018 2019 2020)

DTC P0741 (2016 2017 2018 2019 2020)

DTC P0741  : Torque Converter Clutch Circuit Performance or Stuck OFF

NOTE:
  • Before you troubleshoot, review the General Troubleshooting Information .
  • The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.
DTC Description Confirmed DTC Pending DTC Freeze Frame
P0741 Torque Converter Clutch Circuit Performance or Stuck OFF      

DTC (A/T)

  1. Problem verification

    -1. Turn the vehicle to the ON mode.

    - 2. Clear the DTC with the HDS.

    - 3. Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data.

    - 4. Check for Pending or Confirmed DTCs with the HDS.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
    P0741 Torque Converter Clutch Circuit Performance or Stuck OFF      

    Is DTC P0741 indicated?

    YES 

    The failure is duplicated. Replace the sensor unit (2016 2017 2018 2019 2020) or Replace the transmission - Refer to: Automatic Transmission Removal and Installation (2014 2015), or Automatic Transmission Removal and Installation (2016 2017 2018 2019 2020) .

    NO 

    Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.