DTC P072A (2016 2017 2018 2019 2020)
DTC P072A : Stuck in Neutral
NOTE:
- Before you troubleshoot, review the General Troubleshooting Information .
- The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
- Test the vehicle in this manner only if the traffic regulations and ambient conditions allow.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P072A Stuck in Neutral |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine.
- 4. While pressing the brake pedal, shift the transmission to D position/mode.
- 5. Release the brake pedal.
- 6. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P072A Stuck in Neutral Is DTC P072A indicated?
YES
The failure is duplicated. Replace the transmission - Refer to: Automatic Transmission Removal and Installation (2014 2015), or Automatic Transmission Removal and Installation (2016 2017 2018 2019 2020) .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.