DTC P0711, P0714 (2016 2017 2018 2019 2020)
DTC P0711 : ATF Temperature Sensor (Range/Performance)DTC P0714 : ATF Temperature Sensor (Intermittent Failure)
- Before you troubleshoot, review the General Troubleshooting Information .
- This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
- Drive the vehicle in this manner only if the traffic regulations and ambient conditions allow.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0711 ATF Temperature Sensor (Range/Performance) | |||
| P0714 ATF Temperature Sensor (Intermittent Failure) |
DTC (A/T)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Test-drive the vehicle for at least 10 minutes under the same conditions as those indicated by the freeze data.
- 4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P0711 ATF Temperature Sensor (Range/Performance) P0714 ATF Temperature Sensor (Intermittent Failure) Is DTC P0711 or 0714 indicated?
YES
The failure is duplicated. Replace the sensor unit or substitute a known-good TCM , then recheck. If this DTC goes away and the TCM was updated, troubleshooting is complete. If this DTC goes away and the TCM was substituted, replace the original TCM .
NO
Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals at the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.