LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> MDX SH-AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - DTC Diagnostics (1 Of 2) (Except Hybrid) >> Troubleshooting >> DTC P0700 (2016 2017 2018 2019 2020)

DTC P0700 (2016 2017 2018 2019 2020)

DTC P0700  : Transmission Control System (Mil Request)

NOTE:
  • Before you troubleshoot, review the General Troubleshooting Information .
  • This code is caused by an electrical circuit problem and cannot be caused by a mechanical problem in the transmission.
  • The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
DTC Description Confirmed DTC Pending DTC Freeze Frame
P0700 Transmission Control System (Mil Request)      

DTC (A/T)

  1. DTC check

    -1. Turn the vehicle to the ON mode.

    - 2. Clear the DTC with the HDS.

    - 3. Turn the vehicle to the OFF (LOCK) mode.

    - 4. Turn the vehicle to the ON mode.

    - 5. Check for other Pending or Confirmed DTCs indicated along with DTC P0700.

    DTC Description Confirmed DTC Pending DTC Freeze Frame
           

    Are there other DTCs?

    YES 

    Go to the indicated DTC's troubleshooting .

    NO 

    There are no DTCs along with DTC P0700. Intermittent failure, the system is OK at this time. Check for poor connections and loose terminals at the TCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.