DTC P2229
DTC P2229 : BARO Sensor Circuit High Voltage
NOTE:
Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the A/T System (2014 2015),
or How to Troubleshoot the Fuel and Emissions Systems,
or How to Troubleshoot the Brake Booster Pressure Monitoring System (2016 2017 2018 2019 2020),
or How to Troubleshoot the Fuel and Emissions Systems(With Auto Idle Stop System) (2016)
.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P2229 BARO Sensor Circuit High Voltage |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Check the parameter(s) below with the HDS.
Signal Threshold Current conditions Values Unit Values Unit BARO SENSOR More than 4.95 V Do the current condition(s) match the threshold?
YES
The failure is duplicated. Update the PCM if it does not have the latest software, or substitute a known-good PCM - Refer to: PCM Removal and Installation (2014 2015), or PCM Removal and Installation (2016) .
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.