DTC P16FA
DTC P16FA : PCM Internal Circuit Malfunction (Starter Control Circuit Malfunction)
NOTE:
Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Brake Booster Pressure Monitoring System (2016 2017 2018 2019 2020),
or How to Troubleshoot the Fuel and Emissions Systems(With Auto Idle Stop System) (2016),
or How to Troubleshoot the Fuel and Emissions Systems,
or How to Troubleshoot the A/T System (2014 2015)
.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P16FA PCM Internal Circuit Malfunction (Starter Control Circuit Malfunction) |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS, and wait 5 seconds.
- 3. Start the engine.
- 4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P16FA PCM Internal Circuit Malfunction (Starter Control Circuit Malfunction) Is DTC P16FA indicated?
YES
Update the PCM if it does not have the latest software, or substitute a known-good PCM - Refer to: PCM Removal and Installation (2014 2015), or PCM Removal and Installation (2016) , then recheck.
NO
Intermittent failure, the system is OK at this time. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.