DTC P16F0
DTC P16F0 : PCM Internal Circuit Malfunction (Starter Control Circuit Malfunction)
NOTE:
Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Brake Booster Pressure Monitoring System (2016 2017 2018 2019 2020),
or How to Troubleshoot the Fuel and Emissions Systems(With Auto Idle Stop System) (2016),
or How to Troubleshoot the Fuel and Emissions Systems,
or How to Troubleshoot the A/T System (2014 2015)
.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P16F0 PCM Internal Circuit Malfunction (Starter Control Circuit Malfunction) |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine.
- 4. Check for Pending or Confirmed DTCs with the HDS.
DTC Description Confirmed DTC Pending DTC Freeze Frame P16F0 PCM Internal Circuit Malfunction (Starter Control Circuit Malfunction) DTC (PGM-FI)
Is DTC P16F0 indicated?
YES
The failure is duplicated. Update the PCM if it does not have the latest software, or replace the PCM - Refer to: PCM Removal and Installation (2016), or PCM Removal and Installation (2014 2015) .
NO
Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the PCM. If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.