DTC P0326
DTC P0326 : Knock Sensor 1 (Bank 1) Malfunction
NOTE:
Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the A/T System (2014 2015),
or How to Troubleshoot the Fuel and Emissions Systems,
or How to Troubleshoot the Brake Booster Pressure Monitoring System (2016 2017 2018 2019 2020),
or How to Troubleshoot the Fuel and Emissions Systems(With Auto Idle Stop System) (2016)
.
| DTC Description | Confirmed DTC | Pending DTC | Freeze Frame |
|---|---|---|---|
| P0326 Knock Sensor 1 (Bank 1) Malfunction |
DTC (PGM-FI)
- Knock sensor installation check
-1. Check that knock sensor 1 (Bank 1) is installed correctly.
Is knock sensor 1 (Bank 1) installed correctly?
YES
Installation is OK. Replace knock sensor 1 (Bank 1) . If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.
NO
Installation is not correct, reinstall knock sensor 1 (Bank 1) .