DTC P0130, P0150
DTC P0130 : Rear A/F Sensor (Bank 1, Sensor 1) Out of Range DTC P0150 : Front A/F Sensor (Bank 2, Sensor 1) Out of Range
NOTE:
- Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Fuel and Emissions Systems, or How to Troubleshoot the A/T System (2014 2015), or How to Troubleshoot the Brake Booster Pressure Monitoring System (2016 2017 2018 2019 2020), or How to Troubleshoot the Fuel and Emissions Systems(With Auto Idle Stop System) (2016) .
- Information marked with an asterisk (*) applies to the front bank (Bank 2).
| DTC Description | Confirmed DTC | Pending DTC |
|---|---|---|
| P0130 Rear A/F Sensor (Bank 1, Sensor 1) Out of Range | ||
| P0150 Front A/F Sensor (Bank 2, Sensor 1) Out of Range |
DTC (PGM-FI)
- Problem verification
-1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Start the engine.
- 4. Hold the engine speed at 3, 000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.
- 5. Monitor the OBD STATUS for P0130 and/or P0150 * with the HDS.
DTC Description OBD STATUS P0130 Rear A/F Sensor (Bank 1, Sensor 1) Out of Range P0150 Front A/F Sensor (Bank 2, Sensor 1) Out of Range Does the HDS indicate FAILED?
YES
Replace the A/F sensor (Sensor 1) .
NO
If the HDS indicates PASSED, intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F Sensor (Sensor 1) and the PCM. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot - Refer to: How to Troubleshoot the Fuel and Emissions Systems, or How to Troubleshoot the Brake Booster Pressure Monitoring System (2016 2017 2018 2019 2020), or How to Troubleshoot the Fuel and Emissions Systems(With Auto Idle Stop System) (2016), or How to Troubleshoot the A/T System (2014 2015) . If the HDS indicates EXECUTING, keep idling until a result comes on. If the HDS indicates OUT OF CONDITION, go to step 1-4 and recheck.