VSA DTC 66-13

DTC 66-13  : Pressure Sensor Malfunction

NOTE:  Before you troubleshoot, review the how to troubleshoot the VSA system - Refer to:

How to Troubleshoot the VSA System (2014 2015 2016) or

How to Troubleshoot the VSA System (2017 2018 2019 2020) .

DTCs (VSA)

1. Brake pedal height check

   - 1. Check the brake pedal height.

   Is brake pedal height OK?

   YES 

   Go to step 2.

   NO 

   Adjust the brake pedal height .

2. Problem verification

   - 1. Turn the vehicle to the ON mode.

   - 2. Clear the DTC with the HDS.

   - 3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

   - 4. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame
   66-13 Pressure Sensor Malfunction

   Is DTC 66-13 indicated?

   YES 

   The failure is duplicated. Go to step 3.

   NO 

   Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting - Refer to:

   How to Troubleshoot the VSA System (2014 2015 2016) or

   How to Troubleshoot the VSA System (2017 2018 2019 2020) .

   If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the Freeze data/on-board snapshot.

3. VSA modulator-control unit check (update)

   - 1. Update the VSA modulator-control unit if it does not have the latest software.

   - 2. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.

   - 3. Check for DTCs with the HDS.

   DTC Description	DTC	Freeze Frame

   Is DTC 66-13 indicated?

   YES 

   Check for loose terminals in the VSA modulator-control unit 38P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit .

   NO 

   Troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCs troubleshooting.