VSA DTC 105-11
DTC 105-11 : Solenoid Valve Overheating
NOTE:
- Before you troubleshoot, review the how to troubleshoot the VSA system - Refer to:
- DTC 54-13 can also be stored for overheating. If only DTC 105-11 is stored do not replace the VSA modulator-control unit. The code can be cleared with the HDS once the solenoid has cooled.
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| 105-11 Solenoid Valve Overheating |
DTCs (VSA)
- DTC check
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Turn the vehicle to the OFF (LOCK) mode.
- 4. Turn the vehicle to the ON mode, then wait for a few seconds or more.
- 5. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame 105-11 Solenoid Valve Overheating 54-13 Fail-Safe Relay Power Source Malfunction Is DTC 105-11 indicated?
YES
If only DTC 105-11 is indicated, turn the vehicle to the OFF (LOCK) mode, then wait for ten minutes or more and retest.
YES
If DTC 54-13 is also indicated, go to DTC 54-13 .
NO
The system is OK at this time.