DTC C0044-49
DTC C0044-49 : Master Cylinder Pressure Sensor Failure (Internal Circuit Failure)
NOTE: Before you troubleshoot, review the general troubleshooting information - Refer to:
How to Troubleshoot the VSA System (2014 2015 2016) or
How to Troubleshoot the VSA System (2017 2018 2019 2020) .
| DTC Description | DTC | Freeze Frame |
|---|---|---|
| C0044-49 Master Cylinder Pressure Sensor Failure (Internal Circuit Failure) |
DTC (VSA)
- Problem verification
- 1. Turn the vehicle to the ON mode.
- 2. Clear the DTC with the HDS.
- 3. Turn the vehicle to the OFF (LOCK) mode, then to the ON mode.
- 4. Check for DTCs with the HDS.
DTC Description DTC Freeze Frame C0044-49 Master Cylinder Pressure Sensor Failure (Internal Circuit Failure) Is DTC C0044-49 indicated?
YES
The failure is duplicated. Check for loose terminals and poor connections in the VSA modulator-control unit 38P connector. If they are OK, replace the VSA modulator-control unit .
NO
Intermittent failure, the system is OK at this time. Refer to intermittent failures troubleshooting - Refer to:
How to Troubleshoot the VSA System (2014 2015 2016) or
How to Troubleshoot the VSA System (2017 2018 2019 2020) .
If the freeze data/on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the freeze data/on-board snapshot.