Center Console Rear Trim Removal/Installation

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the center console or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Remove the center console rear trim (A).
1. Starting at the bottom, gently pull out the console rear trim to detach the clips, and to release the hooks (B).
2. With rear seat cushion heater: Disconnect the rear seat heater switch connectors (C).
  
  Fig 1: Identifying Center Console Rear Trim Hooks And Clips
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the rear trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- With rear seat cushion heater: Make sure rear seat heater connectors are plugged in properly.
- Push the clips and the hooks into place securely.